3-1 Group A Discussion Paper: Multi-Voting Process Tool

Week 3 - Module Three Group Discussion Guidelines and Rubric (located under Assignments & Rubrics)
Before starting this assignment you must perform the THINGS TO DO list below. 
THINGS TO DO:
Be sure to read the Module 3 Group Discussion Guidelines and Rubrics carefully and thoroughly for a clear understanding of the content being graded.
Review Module Three Lecture: “Regulatory Approaches, Economics, and Process Analysis Tools".
Read Chapters 3 & 4 of the Quality Management book
READ THE INSTRUCTIONS TO THIS PROBLEM VERY CAREFULLY.
MULTIVOTING PROBLEM
QM TEAM PREFERENCE
Jacob D I B C A F E J H G
Isabella A C E F G J D H I B
Ethan H G E D B I J A C F
Emma D I F A E G B C H J
Olivia B G A J H C F E I D
As you begin thinking about this project, consider using tables (such as those below) to help you work through the problem. I am a visual learner so some of the HINTS provided are one's I use to keep me on track.
FOR THE 1ST VOTE assign 3 points to each member's 1st choice (see 1st Vote column); 2 points to the second, and 1 point to the 3rd choice. 
Round 1 Vote
Options
3 Points
2 Points
1 Point
Total After totaling, 1) eliminate all Options with totals of less than 3, then 2) carry forward only those options that remain to the Round 2 Table
Hint: consider “Xing” out all of the Options you eliminated on the Table above. This will provide you a better visual of what remains to be used.
A
B
C
D
E
F
G
H
I
J
Round 2 Vote (assign 2 points for each member's 1st choice and 1 point for the 2nd choice)
Remaining
Options
2 Points
1 Points
Total
After totaling: Continue to eliminate low vote tallying options until only two (2) Options remain. If you “X'd out those options eliminated in Round 1 you should be able to visually see what Options remain available for vote in Round 2
Hint: consider placing an over all of the Options you eliminated in Round 2 (on the Table above). This will provide you a better visual of what remains to be used